Deleting or Moving Sensors
If you wish to change a sensor from one tyre to another, or replace a sensor on a particular tyre
that sensor must be deleted from its original position first and any sensor already programmed
into the new position must also be deleted from the monitor.
1.
Put the monitor into Tyre Alignment Mode by pressing and holding the left and right
buttons simultaneously until the monitor beeps.
2.
Press the left or right button to select the tyre position you wish to delete or change a
sensor on.
3.
Remove the sensor from the tyre.
4.
Hold down the centre button for that tyre position until the monitor beeps and three dashes
appear instead of a pressure reading for that position.
5.
Repeat steps 2-4 for any other tyre positions that you wish to delete/change.
6.
Re-install sensors using instructions for
Programming Sensors
above.
Deleting All Sensors
If you wish to delete all sensors to re-align all sensors:
1.
Put the monitor into Tyre Alignment Mode by pressing and holding the left and right
buttons simultaneously until the monitor beeps.
2.
Press and hold both the left and centre buttons until the monitor beeps. This will delete all
sensors from the monitor.
3.
Re-install sensors using instructions for
Programming Sensors
above.
Turning The Monitor Off
To Turn the Monitor Off, ensure the Monitor is no longer in programming or alignment mode then
press and hold the middle button for about 8 seconds until the display disappears. It will beep as
it goes back into programming mode but do not release the button until it turns off.
