LABEL OF INDIVIDUAL COMPONENTS
6
7
4
5
1
2
3
1. Mouthpiece and Mouthpiece Slot
2. Digital LC Display
3. Power Button
4. Air Outlet (always keep this part unblocked)
5. Menu Button (for different device settings)
6. Connection for the USB Charger Cable
7. Button to switch on the power supply
INNOMARK gamma
BREATHALYZER
Quick Start Guide – EN
(please read the manual for further details)
CONDUCTING THE MEASUREMENT
1.
Push the switch below the USB cable connection upwards.
2.
Check if the Battery is fully charged (use the supplied USB cable
for charging).
3.
Briefly press the start button on the front of the alcohol tester. The device
beeps twice and „ALCO“ and the battery indicator appear on the display.
4.
Press the start button again once briefly, „SH“ will appear briefly, then
„SH99“ and then a countdown will start counting from 30 to 0.
During the countdown the unit beeps every second and the display
alternates between „READY“ and „BLOW“.
5.
Once the countdown starts, you can begin the breath test. Blow steadily
into the previously attached mouthpiece for 4 seconds. Breathe out
slowly and without interruption (as if you were whistling without a tone).
The device beeps continuously during the breath test.
6.
As soon as the beep stops and a click tone and a double beep tone can
be heard, the test is finished. If the breath sample was interrupted or too
weak, „FLO“ appears on the display. In this case, perform the test again
and press the start button for 2 seconds.
7.
After a successful breath test, the instrument evaluates the measurement
result. The display briefly shows „Anly“ and then immediately the result
in per mille (= standard setting of the measuring unit in the EU). The
measuring result can be seen for about 60 seconds, then „ALCO“ appears
again on the display. For a new test, briefly press the start button once.
PLEASE NOTE
•
Wait at least 15 minutes after finishing your last drink.
•
From hygiene reasons and for accurate measurement results always use
a new mouthpiece for each test.
•
The default measurement setting for EU is per mill, for UK it is mg/L and
for the USA it is % BAC.
•
All measured values determined by this breathalyzer are always a guide
only and are not legally binding.