18
BATTERY INSERTION
1. Gently slide the battery compartment cover and remove it from the device body.
2. Insert 2 AA batteries paying attention on polarities. Replace the battery
compartment cover
TIPS
Cut the hair calmly and with a steady hand. Make short passes and gradually work
on the entire head.
Cut by taking a single strand or area at a time, and in case go over it later.
To get the desired cut, comb the hair often.
To make the best use of the hair clipper, the hair must be dry and not damp. With
dry hair it is easier to control the cut and how much is to be cut.
Cutting hair requires practicality so it is always better to leave the hair longer for
the first few times in order to become familiar with the use of the various combs.
Combs supplied (refer to the main image)
Comb I: suitable for hair up to 3mm in length
Comb II: suitable for hair up to 6mm in length
Comb III: suitable for hair at 9mm in length
Comb IV: suitable for hair at 12mm in length
The numbering of the comb is shown on the central part of the comb itself.
To insert the comb, place it with the teeth facing up and slide it along the blades.
To remove the comb, push up and remove it from the blades.
For an even cut, slide the comb and the blades of the hair clipper through the hair,
without forcing and without moving too quickly. Remember to comb the hair often
in order to remove residues and check that the cut is uniform.
STEP 1 - NAPE
1. Use the 3 or 6 mm comb
2. Hold the hair clipper in a vertical position with the blades facing upwards, and
start cutting from the center of the head up to the nape of the neck. (picture 1)
GB
