14
GB
2. Lift the lid (see picture #3) and fill the tank with soap
or sanitizing gel through the hole, paying attention
not to overcome the maximum level. Make sure the
amount of soap liquid or gel is over about 1/8 height
of the dispensing tank.
3. Reposition the lid, in order to close
the tank.
DISPENSE OF GEL OR SOAP
1. Be sure that the ON/OFF switch is set on ON. A built-
in white LED light will illuminate the tank, when
dispensing soap/gel.
2. For the first use place the hands below the nozzle
and keep the position until the motor stops. Repeat
this operation more times if the gel/soap is not
supplied.
3. For the next uses, keep the hands below the nozzle
until the needed quantity of gel/soap is supplied.
The flow stops when the hands are not below the
sensor.
4. If the unit does not dispense, please check if:
- the spout or dispensing tube is blocked because of
long no-use or cold/dry weather.
- the batteries are inserted correctly and are new.
- the ON/OFF switch is in the ON position.