© InnoFlight All Rights Reserved. 2016
2
Meditate Gimbal Quick Release
The Meditate gimbal is equipped with a quick release system for your convenience.
1. To release/install the gimbal you only need to loosen the two M3 x 12mm bolts
2. Unplug the GCU interface cable from the bottom of the payload mounting plate
3. Slide the gimbal assembly out.
Starting/Stopping the Motors
The start and stop (arming) the motors, please perform any one of the following control stick combinations.
•
When motor is armed, the Green, Blue, and white LED will blink rapidly for one second
•
When motor is disarmed, the Green, Blue, and white LED will blink slowly for one second
Please also note the following conditions:
In Manual Mode - when the motors are armed and the throttle stick remains below the mid-point for more than
5 seconds, the motors will turn OFF. If the throttle stick is raised above the mid-point within 5 seconds then the
motors will remain ON.
When landing in GPS/Attitude Mode - If the throttle stick is kept below -90% then the motors will turn OFF af
-
ter 5 seconds however for added safety we suggest you always manually disarm the motors immediately after
landing.
Summary of Contents for Stellar X1000
Page 1: ......
