23
WAN Service
In DSL mode, you are required to configure parameters for ATM interface.
To enter the ATM Interface page, click “
Advanced Setup
”---“
Connection Mode
” (Select
DSL mode and click “
Apply
”)--- “
WAN Service
”---ATM Interface. And then click “
Add
”
to configure the relevant parameters.
On this page, you can configure VPI and VCI values (consult your local ISP if you are not
clear). For other options, keep the defaults and click the “
Apply/Save
” button. Below
you find details on the parameters.
Field
Description
VPI/VCI
Enter the PVC identifier (VPI and VCI) provided by your ISP.
DSL Link Type
Select the DSL link type for the connection. Your ISP should inform you
which type to use.
Connection
Mode
Select the connection mode according to your application.
Encapsulation
Mode
Select the encapsulation mode for the connection. Your ISP should
inform you which mode to use.
Service
Category
Select the encapsulation mode for the connection. If you are not sure
which type to select, just use the default type.
UBR without PCR
: This service mode does not provide assurance
about the cell latency, the bit loss rate, etc. it is a best-effort
service.
UBR with PCR/ CBR
: This service mode provides constant rate
