16
17
ADVANCED settings
In advanced settings, there are settings for SP SmartPairing,
FS Factory settings, SE Season settings, CA Calibration
settings and HS Hysteresis settings. In the next couple of
pages each setting will be explained in details.
SmartPairing mode
SmartPairing allows easy connection of the thermostat with
the receiver.
2.
Press the left or right button to navigate to the symbol
, select program symbol and press and hold the middle
button to enter the program setting.
3.
Press the LEFT or RIGHT button, select the ALL to set
temperature automatically for all days in the week.
4.
Press the LEFT or RIGHT button to change for which half
an hour you want to set the temperature.
5.
Press the MIDDLE button to change between ANTIFROST
/ECO/COMFORT temperature for the selected half hour.
6.
Hold the MIDDLE button to go back.
Overview of All Days program setting
1.
Open the ADVANCED SETTINGS display.
2.
Navigate with the RIGHT and LEFT button until you
reach the “SP” option.
3.
When “SP” flashes, press the MIDDLE button and hold
it for 5 seconds.
4.
Now it should show the symbol SP on the side, and
00 will flash on the screen in the center, until it finds the
device. When the device is found, it shows 01.
5.
Start SP mode on the receiver by pressing and holding
the button until the green light signal appears.
6.
Release the button on the receiver on the green light
signal and then the green light will flash.
7.
You have now entered SP mode on both devices and you
need to wait until the devices are paired with each other.
8.
The connection status of the device is known when the
lights are no longer flashing but the lights are steady green
and the thermostat displays the home screen.
In case of adding another receivers that was already
added to the network, we need to reset the desired
receiver to factory settings which will be explained in the
next few pages.
Symbol SP starts to blink when entering the SmartPairing mode.