7
Rev 1.0 July 2016
Graphic Terminal and enter the new number using the <DIGIT> keys. Use the
<Delete> Function key to backspace if you make an error. Press <OK> to save the
new Module number.
c) Press <Exit> when complete.
Setup.
1. Enter Setup Mode.
Logon with the Installer PIN code, press <MENU>, then “Setup” (7 key), then
“Terminal” (1 key).
At any time, the following keys (if displayed) may be used:
<Back> function key:
Scrolls back through the configuration screens.
<More> function key:
Scrolls forward through the configuration screens.
<END> key:
Exits config and returns to the normal display.
2. Terminal Setup options. 2 screens.
a) Use the <UP> & <DOWN> Arrows or Scrollwheel to select the option to change.
b) Press <ON> to enable, or <OFF> to disable the check-box type option.
c) The <LEFT> & <RIGHT> Arrows can be used to change the Colour Scheme.
d) If changes are made, press <OK> to save the changes and step to the next screen.
2.1 Audio, RFID (future enhancement) & Custom Keypad Colour options.
•
Audio auto-off. The speaker is muted when no audio is present, to eliminate
background noise. This may be preferred in quiet areas e.g. bedrooms. If enabled,
a short delay may occur between the re-appearance of an audio signal, and the
speaker being un-muted.
•
Enable RFID ASK support. (Not yet available)
•
Enable RFID HID support. (Not yet available)
•
Enable custom keypad RGB. (If enabled, adjust the RGB values in Step 3.2)
2.2 Keypress options & Factory reset.
•
Enable red flash on error.
•
Enable keypress flash.
•
Reset all to factory defaults.
3. Terminal Preferences. 4 screens.
a) Use the <UP> and <DOWN> Arrows to select the setting to change.
b) Use the SCROLL WHEEL to change a level setting, <ON>/<OFF> for check-box
options.
c) If changes are made, press <OK> to save the changes and step to the next screen.
