3. Ensure the entries in the
Connection Parameters
and
QoS Parameters
sections are the
same as the ones you want. If that is not the case, make the changes first and then select
Update
Profile
and ensure the connection profile you want to update is selected from the scroll-down menu.
4. If you want to go over the air, follow the steps in
and
Connection for On-Air Operations
to establish a data connection using the connection profile
you have just created.
10.13.2: Establishing a Data Connection for On-Air Data Operations
1. Select
Connection
from the
Engineering WebUI
main menu.
The
Connection
page loads up. The
Profile Id
field in the
Profile
section should be populated
with
Test
.
2. Select the
Get Profile
button.
The
Connection Parameters
and
QOS Parameters
sections of the
Connection
page are
auto-populated with the pre-defined
Test
connection profile parameters.
Note:
If you did not get a positive response to
Step 13
in
Connection for On-Air Data Operations
, then before you carry out
Step 3
, wait for a
few seconds until the BRM has established a connection with the satellite.
3. Under the
Connection
section of the
Connection
page, select the
Create Connection from
Profile
button.
4. Select the
Get Connection List
button to see what the connection status is.
The connection is fully established once the status shows per
.
69:
BGAN Radio Module Terminal Development Kit User Guide
Confidential and Proprietary – Inmarsat Global Limited
