Inline IN2118, Operation Manual

Page: 9 / 27

7
©2001 - Inline, Inc. IN2118 Operation Manual - Preliminary 01/31/01
ADJUSTING THE IN2118
This section offers step-by-step instructions for precisely situating the IN2118 in the table /
presentation furniture. An Adjustment Diagram is provided on the following page.
Do not permanently attach the cover surface (lid) to the top plate until the
IN2118 has been fully installed in the table / presentation furniture.
1. Center the IN2118 until a roughly equidistant gap is achieved between all four sides of the
top plate and the table’s opening (once again, a precise adjustment will be done later).
Once the unit has been properly positioned in the table, tighten the four (4) primary screws.
2. Loosen the upper wing nuts and disconnect the main housing. Carefully drill the (4)
secondary holes and secure the mounting flange to the table. Once again, care must be
taken not to penetrate the surface of the table.
3. Reattach the main housing to the mounting flange. Using the IN9230 IEC Power Cable
(included), apply power to the IN2118, turn it on, and press down on the top plate surface
to raise the unit.
4. With the IN2118 in the raised position, place a Carpenter’s Level across the top of the
plate and level the unit by adjusting the upper wing nuts. When the unit has been
centered, turn the Level 45º and adjust again. This step may have to be repeated several
times until a true level surface is achieved.
Note: Leveling the unit while in the raised position will ensure that the top plate and the table
surface remain parallel (when the IN2118 is in the raised position), and sits flush when the unit
is fully descended.
5. Before adjusting the height of the interface, use two-sided tape to temporarily attach the
cover surface material (lid) to the top plate.
6. To adjust the height of the IN2118, press down on the lid and lower the unit. Loosen the
four (4) lower wing nuts. Position the lid so that it sits completely flush with the table
surface and tighten the wing nuts. Raise and lower the interface to ensure that the unit
achieves sufficient clearance when raised, and sits flush when lowered. The IN2118
should ascend and descend smoothly.
The lower wing nuts allow installers to adjust for varying tabletop thickness
(up to two inches) and provide a precise flush-mount installation
7. Using a strong adhesive, permanently attach the lid to the top plate.