Inkbird IIC-800-WIFI, User Manual

Page: 26 / 33

Power Supply Connection
• This controller adopts adapters following local safety regulations' certification,
convenient and safe.
• Insert the power output end into the PWR IN jack of the device.
• Put power lines into the line slots of the device.
Note:
• The 24 VAC- port is a common port.
• You must connect the S1 port and S2 port with the 24 VAC- port if there is no rain
sensor connected.
Note:
Please do not turn on the power before confirming all lines are well-connected.
• Please cut off the power of the line if it's damaged. In that case, we suggest changing
a replacement line to avoid possible harm.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate the equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help. This equipment
complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
23