Screw the m6 vibra-mount into the front pre-threaded
hole on the bracket used to mount the air box cleaner.
The vibra-mount is now attached and in place.
Position the primary pipe into the 2 7/8” straight hose
located on the throttle body. Leave the clamp snug but
loose to later adjust the pipe for best fitment
Locate the mass air flow sensor and insert it into the
machined sensor adapter.
Connect the crank case breather line to the welded
nipple on the intake pipe
Page 3 of Part# SP1870
Figure 14
Figure 15
Figure 17
Figure 18
Figure 19
Place the 2 7/8” straight hose and two clamps on the
throttle body
Figure 16
Place two M4 allen bolts onto the MAF sensor.
Use a 2.5mm allen wrench and secure the MAF sen-
sor to the machined flange welded on the intake pipe
Re-connect the MAF sensor harness back onto the MAF
sensor. Make sure you heard it snap in place.
Figure 20
Figure 22
Figure 21
Press the 3” hose over the end of the primary intake.
The 3” hose should not cover more than 1” of the edge
of the intake. Use two power-bands and tighten the
clamp on the intake side for now.
Connect the primary tube to the secondary tube while
aligning the intake bracket to the vibra-mount.
Lower the secondary intake into the engine compart-
ment and into the opening leading into the bumper
area.
Figure 23
Figure 24
Figure 25
