Once the filter has been installed on the secondary intake lower the filter end
into the compartment below the battery tray.
Line up the intake bracket to the vibra-mount stud and use a fender washer and a
flange nut to secure the intake in place.
To continue the installation of the cold air intake take the 3” straight hose and
press it over the end of the primary intake. Use two clamps on the hose but
only tighten the clamp on the intake side (A).
Press the Injen filter over the end of the secondary intake as shown above. Be
sure to tighten the clamp on the filter neck.
Take the 8”-15mm hose and press one end over the crankcase port (A). Take
the other end of the hose and press it over the air intake port (B) and (C).
The filter is pressed over the end of the primary intake and used as a short ram.
Injen recommends using the short ram in rainy days in order to avoid hydrolock-
ing.
Take the primary intake and press the straight end into
the 90 degree elbow as shown in this picture.
The primary intake is now installed and in place.
While the intake is pressed into the silicone elbow the
bracket is lined up the the first vibra-mount stud. as
shown above. Use the m6 flange nut and fender
washer to hold the intake in place.
(A)
(B)
(C)
(A)
<<<<
<<<<
)
