Page 5 of Part# SP1126
The Power steering reservoir bottle cup bracket and Injen power-scoop installed in the BMW 335i
Position the injen power-scoop to the back of the core
support, locate the 1 insert though the scoop. Secure
the power-scoop using the M6 button head screw.
Secure the plastic push clips to the factory scoop.
Position the bracket to the power steering resovoir
bracket thredded insert. Secure using the remaining
M6 button head screw and tighten. This will allow for
support of the power-scoop.
(NOTE: you should
have 1 remaining flange nut, please discard)
Install the factory scoop, secure the passenger side
using the M6 button head screw and flange nut
behind the core support.
Make sure the spacer is used to preventing the brack-
et to distort. Tighten using allen key till bottoms out.
Install the resovoir into the cup and secure.
Note:
Make sure the resovoir bottle sits all the way down
and tight.
The stock m6 bolt is used to fasten the extended
bracket located on the new power steering cup.
Install the M6x35mm bolt through bracket, now install
the spacer to the bolt. Position the bolt to the back
side of the thredded insert from previous step.
A) Loosen the bolt on left side of core support hold-
ing in headlight using T30 torx bit. B) Remove the
bolt from vehicle.
Use provided flange nut and secure the bolt. Tighten
using 10mm socket and ratchet.
Drill both holes out to 1/4” on the factory scoop to
make the M6 screws able to pass through.
Install the Air scoop bracket to the power-scoop.
secure using M6 button head screw.
Figure 39
Figure 40
Figure 41
Figure 42
Figure 43
Figure 44
Figure 45
Figure 46
Figure 48
Figure 49
Figure 50
Install the injen power-scoop only to see how you
will only be able to line up the 1 hole closes to the
power steering resovoir bracket.
Remove the screw.
Figure 47
A
B
