56
Apollo Devices
Installation manual
1. Remove the detector from its base (twist off).
2. Using a flat-bladed screwdriver or similar tool, push the locking tab and slide the Xpert card out of its
holder.
3. Using a flat-bladed screwdriver or similar tool, remove the pips in such way as to assign an address to
the Xpert card (refer to the Address Table in the device instructions).
Note:
126 addresses are available.
4. Using a felt-tip pen or printing device, write/print the respective address on the break-off tags.
Note:
This labeling method will provide visual identification of the system detectors during the system
installation phase. When you think you have the system detectors properly wired and addressed, you can
either break off the tags or leave them for future reference.
5. Replace the card.
6. Fit the detector to its base.
C.9.2
Addressing APOLLO modules
You can address all modules in the APOLLO range (Input,Output, In/Out, Manual Callpoint/Sounder/
Flasher/Emergency Light, etc.) using the incorporated DIP switches (see following figure).
1. Using the On/Off position of the incorporated DIP switch (refer to the Address Table in the device
instructions), set the module address
(from 1 to
126).
2. Connect the module to the motherboard.
Summary of Contents for SmartLoop Series
Page 58: ...58 Notes Installation manual Notes ...
Page 59: ...Installation manual 59 ...
