2. Description Air2-MC200
2. Description Air2-MC200
The magnetic contact Air2-MC200 is supplied with a magnet which is to be secured (by means of two
screws) to the side of the contact, in the position indicated by the two notches.
Air2-MC200 it also integrates a shock and a tilt sensor that allow its use without the need of the magnet.
Air2-MC200 it is equipped with open and dislodgement tamper protection.
The device uses separate channels for the different types of signalling, thus allowing precise identification of
the alarm source.
.BHOFUEFUFDUJPOSBOHF
The following table indicates the distance in millimeters of the operating capacity of the magnet depending
on the side in use and the axes illustrated in the figure (values starting from a nominal distance of 10mm,
except for axis y-):
Axis
Distance between magnet and contact (mm)
Near
Withdrawn
x +/-
14
18
y -
14
18
z +/-
18
22
4IPDLEFUFDUJPO
Signalling of shock waves is achieved through a tri-axial vibration detector. The vibration sensibility can be
set either from a keypad or via the programming software application.
5JMU EFUFDUJPO
Signalling of tilting (angle change) is achieved through tri-axial tilt sensing. The tilt-variation value (angle) can
be set in relation to the standby position, which is saved to the memory during the reset-after -alarm phase.
/PUF
The device programming allows, besides magnet detection, the use of only one other type of detection, to be
enabled between the detection of shocks and that of tilting.
The shock and tilt sensors are not subject to certification of this product.
4
Installation and programming manual- 100-DRAFT
