
You can press the Reset button to restore default settings as follows.
Step 1: Power on the device and press the Reset button at the same time. About 15 seconds later, only the System LED
indicator is turned on in red.
Step 2: Release the Reset button when the System LED indicator is turned off and then turned on in red.
Step 3: Press and hold the Reset button for 1 second when the System LED indicator is turned on. Then, release the
Reset button.
After step 3, the System LED indicator blinks for 2 to 3 seconds and then turns off. In this case, the device is successfully
restored to default settings.
Dial-up: After the dial-up function is enabled on the Network > Cellular page, Connected and the allocated IP address
are displayed in the status bar. In this case, the device is successfully connected to the Internet, and the Cellular
indicator is steady on in green, as shown in Figure 1.
GNSS: After the GPS function is enabled on the Services > GPS page, the gateway location is displayed in the status
bar, indicating that the GPS function is normal, as shown in Figure 2.
OBD: The OBD function is normal if Connected is displayed on the Services > OBD page and data is uploaded, as
shown in Figure 3.
Figure 1
Figure 2
Figure 3
6. Default Setting Restoration
VG710 Onboard Gateway Quick Start Guide
6 / 6