7
6
Caution:
Do not connect the lamp to the power supply
until the assembly is completed.
Enclosed:
1 electronic ballast
Assembly
Stand the lamp upright on a table and insert the ballast plug
in the lamp cable connector.
Attach the LED film (
1
) to the hooks (
2
) on the retaining
rods.
Plug the lamp into the mains socket.
On-off switch and dimmer
To switch the light on, briefly touch the lightning symbol
on the LED film. Touch again to switch off. To adjust the
brightness, keep your finger on the symbol until the desired
level is reached.
Important:
Do not be alarmed if a short flash occurs while
dimming; this indicates that maximum brightness has been
reached.
Adjusting the position of the lamp
The ball joints allow for adjustment within a limited range.
Important:
Avoid placing the LED film under strain when
altering the angle of the retaining rods.
English
Cleaning
The lamp can be cleaned with a dry, lint-free cloth or a
feather duster.
Important:
Contact with cleaning fluids or sprays can
damage the LEDs.
Technical specification:
110-230 V, 50/60 Hz. 110-230V, 50/60 Hz.
The lamp has a
wide-range input power supply for operation with 230 V or 125 V.
Secondary 48 V DC, electronic ballast with plug.
Transparent plastic film with 750 integrated LEDs, 23 W,
2600 lm, 3000 K, CRI 90. The lamp unit contains integrated
LEDs of the energy class A. According to the manufacturer,
LEDs of this class have an average life of 50 000 to 60 000
hours. In the event of damage to the LEDs, replacements
may only be fitted by Ingo Maurer GmbH.
Any repairs that may become necessary must be carried
out by a qualified electrician. In the event of damage to the
power cord, replacements may only be fitted by Ingo Maurer
GmbH.
English
1
2
3
