Inglis Drink-Aide, Manual

Page: 4 / 12

Components
• Water bottle, lid, insulating sleeve
• White tube within its flexible gray tube holder
• White locking nut
• Black bottle holder with universal mounting clamp
• Packet of bolts, nuts and mounting-option attachments
• Two 1'' washers
Assembly Instructions
We recommend that you wash the Drink-Aide
®
before its first use.
Please refer to the section entitled “Care for Your Drink-Aide.
®
”
1. Unscrew the lid and remove all contents from the bottle
(the bottle is wrapped by an insulated sleeve).
2. Verify that the white tube extends at least six inches beyond
the black threaded end of the gray flexible tube holder; adjust
the length if necessary.
3. Hold the gray flexible tube so the black threaded end is
pointing up. Slide 1'' washer over the white tube onto black
threaded end. With top of lid facing down, slide lid over the
white tube onto the 1'' washer, then slide the other 1'' washer
over the white tube onto the lid.
4. Face the flanged or flat side of the white locking nut toward
the 1'' washer and slide locking nut over the white tube onto
the 1'' washer.
5. Screw the locking nut onto the threads of the tube holder;
tighten the locking nut finger-tight; the lid is now held tightly
by the gray tube holder, 1'' washers and white locking nut.
6. Put the long end of the white tube into the bottle (the end of
the clear tube should at least touch the inside bottom of the
bottle) and screw the lid to the top of the bottle.
The Drink-Aide
®
(without liquid contents) is now correctly
assembled. The assembled Drink-Aide
®
may now be placed
within the bottle holder assembly depending on your mounting of
the complete device on a wheelchair, bed rail, etc.
2