INGICS
TECHNOLOGY
Access Point, when it is ready, then press the WPS button on the iGS01S device( the WPS button
needs to be pressed for over 1 sec) to join it.
Reset to Default
In case you need to go back to the original settings, keep pressing the reset/default button
in your device for over 5 secs no matter in which mode the device is. The WiFi LED will be turned
off and when you release the button, the iGS01S will reboot to its default settings(AP mode).
Firmware Upgrade
Check AP002_iGS01_Firmware_Upgrade for details.
LEDs
There are two LEDs to indicate current status like the right figure. The upper one is BLE LED and
the lower one is WiFi LED. Below are their behaviors.
On
Flash
BLE LED
find tag/beacon in range
BLE transmission happening
WiFi LED
AP mode: AP is ready for
connect
Station mode: connect to
assigned AP successfully
WiFi transmission happening
The device quickly blinking
while joining AP during boot
Create Connection
iGS01S is in Access Point(AP) mode defaultly. If you have no idea what mode currently it is in,
please press the multi-function button to reset it to the default state. In AP mode, you could scan and
connect it with the WiFi of your NB/PC/Mac/Tablet/Smartphone. It’s name is just like the above figure
with part of the mac address. The default key to connect with it is “12345678”. You can change it later
when you get into the web UI.
After connection, enter IP address 192.168.10.1 in your browser. The default account/password
are both “admin”. You can change the password later. In web UI, any change needs to be saved first.
After all changes made, click reboot to make the changes effective. When In Station mode, the IP
address of the iGS01S is assigned by the other AP. To get into the web UI, you have to find the assigned
IP address. The following sections describe details of the web UI.
INGICS TECHNOLOGY CO., LTD. • [email protected] • WWW.INGICS.COM
4
