Ingersoll-Rand VON DUPRIN 7311, Operation Manual

Page: 12 / 17

Additional Commands for 7308 Board:
Command
44
45
51
Function
Set door-held-open time.
Default: After 10 seconds, actuates relay
3. Resets
when door is closed or a valid code is entered.
Set door forced-open time.
Default: Actuates relay
3 for 10 seconds, Resets
automatically after time expires.
Add duress user.
This code activates the main relay for the master
code time to unlock the door and also activates the
duress alarm output relay
4 for 10 seconds.
Code Entry
44#T#O#**
T =
10
to 900 seconds
45#T#O#**
T = 10 to 900 seconds
51#O#U#Code*Code*
U= user position 2 to 100
Code = 2 to 6 digit number
EXAMPLE: Adding User Codes
Code Sequence:
COMMAND #
CC#
TIME #
T#
USER POSITION #
U#
CODE *
CODE * CODE *
CODE *
STEP 1: Enter program mode: 99# [master code]*
Response: yellow LED slow flash
STEP 2: Enter command: CC# (Program Command
function)
Add user CC =50
Add duress user CC =
51
Add lockout user CC = 52
Response: yellow LED slow flash
STEP 3: Enter time: T# (0 to 90 seconds)
If T = 0, code will toggle the lock (locked to
unlocked or vice versa). If set to 3, time
equals the master time set in position
number 1. Any other number will set a
unique time for this user.
Response: yellow LED slow flash
STEP 4: Enter the USER position: U# (1 to 100)
Response: yellow LED slow flash
STEP 5: Enter the user code: [_ _ _ _ _ -l* (2 to 6
digits)
Response: yellow LED fast flash
STEP 6: Verify user code was entered correctly:
[_ _ _ _ _ -l* (same 2 to 6 digit number)
Response: yellow LED slow flash
STEP 7: To program another command begin at
step 2, or
STEP 8: To end program mode PRESS the * key
again.
Response: yellow LED stops flashing