ND-Series Service Manual
89
Standard Installation Instructions
C. Mortise Cutout for Latch
Using faceplate as a pattern, mortise cutout for latch.
(Faceplate should fit flush with door.)
Faceplate
Mortise
⁵⁄₃₂
" (4 mm) deep
Install Latch
a.
Slide latch into hole with beveled side of latch toward door jamb.
b.
Secure latch with two (2) latch screws.
1
Lock Installation
b
Bevel
D. Prepare Door Jamb
a.
Mark vertical line and centerline on door jamb exactly opposite
center of latch hole.
b.
Drill holes as shown.
c.
Mortise a cutout for strike. Use strike as a pattern for mortise.
(Strike should fit flush with door jamb.)
Latch Screw
2
Remove Assembly From Box
a.
Leave outside lever and chassis together.
b.
Remove inside lever by inserting pin wrench into hole and
depressing lever catch. Pull lever straight off. (For keyed levers,
see KEYED LEVER section.)
c.
Remove inside trim parts as shown. (Rose may already be
removed.)
Pin Wrench
Chassis
Outside Lever
Rose
10-025 Strike
⁵⁄₁₆
" (8mm)
⁵⁄₁₆
" (8mm)
1
" (25mm)
1
" (25mm)
C
L
L
C
Summary of Contents for Schlage ND Series
Page 1: ...ND Series Service Manual...
Page 3: ...ii ND Series Service Manual...
Page 92: ...ND Series Service Manual 87...
Page 109: ...ND Series Service Manual 104 Notes...
