16572588_ed1
EN-6
26. Check the free speed of the tool using a tachometer and
following the instructions in the
SPEED ADJUSTMENT
section of this manual.
Troubleshooting Guide
Related Documentation
For additional information refer to:
Air Drill Product Safety Information Manual Form 04580353.
Air Drill Product Information Manual Form 16572281.
Air Drill Parts List Manual Form 16572851.
Manuals can be downloaded from www.irtools.com
Troubleshooting Guide
Trouble
Probable Cause
Solution
Loss of Power
Low air pressure.
Check air supply. For top performance, the air pressure
must be 90 psig (6.2 bar/620 kPa) at the inlet.
Plugged Inlet Bushing Screen.
Clean the Inlet Bushing Screen using a clean, suitable,
cleaning solution. If the Screen cannot be cleaned,
replace it.
Worn or broken Vanes.
Replace the
complete
set of Vanes.
Worn or broken Cylinder.
Replace the Cylinder if it is cracked or if the bore
appears wavy or scored.
Exhaust control restricted.
Make certain the Exhaust Diffuser is in the fully open
position.
Motor won’t run
Motor Clamp Washer binding.
Remove the Gear Case make certain the Washer is flat
and the Motor Seal is properly positioned.
Gears binding.
Clean and inspect all gearing. Replace any worn or
damaged gearing.
Leaky Throttle Valve Worn Throttle Valve and/or Throttle Valve Seat.
Install a new Valve and/or Seat.
Dirt accumulation on Throttle Valve and/or
Throttle Valve Seat.
Clean or replace the Throttle Valve and/or Throttle
Valve Seat.
Gear Case gets hot
Excessive grease.
Clean and inspect Gear Case and gearing parts and
lubricate as instructed.
Worn or damaged parts.
Clean and inspect the Gear Case and gearing.
Replace worn or broken components.
