Ingersoll-Rand HP1300WCU, Operating, Maintenance & Parts Manual

Page: 47 / 75

47
( )
Book 54757919 (5/02)
High Compressor Discharge Temperature:
Ambient Temp. > 115
_
F
Out of Level > 15 degrees
Low Oil Level
Wrong Lube Oil
Dirty Cooler
Dirty Operating Conditions
Clogged Oil Filter Elements
Loose or Broken Belts
Operating Pressure Too High
Recirculation Of Cooling Air
Malfunctioning Thermostat
Malfunctioning Fan
Defective Oil Cooler Relief Valve
Defective Minimum Pressure Valve
Blocked or Restricted Oil Lines
Airend Malfunctioning
Above spec limit.
Relocate or reposition unit.
Add oil. Look for any leaks.
Check spec in this manual.
Clean exterior surfaces.
Move unit to cleaner environment.
Replace elements. Change oil.
Tighten or replace belt set.
Reduce pressure to spec.
Close side doors. Replace belly pan.
Replace thermostat in bypass valve.
Check fan belt tension. Tighten or replace belt set.
Replace valve.
Repair or replace valve.
Clean by flushing or replace.
See Complaint 11, 12, 13, 15, 16 or 18.
6.
Corrective Action
Low Engine Oil Pressure
Low Oil Level
Out of Level >15 degrees
Wrong Lube Oil
Clogged Oil Filter Element(s)
Engine Malfunctioning
Loose Wire Connection.
Alternator Low Voltage
Loose or Broken Belts
Loose Wire Connection
Low Battery Voltage
Add oil.
Relocate or reposition.
See Engine Oil Spec. Change oil.
Replace element(s).
See Trouble Shooting in Engine Manual.
Repair or replace.
Tighten or replace belt set.
Repair or replace connection.
Check electrolyte level. Add if necessary.
Check connectors. Clean & tighten.
Recharge battery.
Repair or replace alternator.
4.
5.
Corrective Action
Malfunctioning Alternator
Engine RPM Down:
Clogged Fuel Filter (primary)
Operating Pressure Too High
Dirty Air Filter
Wrong Air Filter Element
Engine Malfunctioning
Airend Malfunctioning
Replace primary filter. Replace final filter. Drain
tanks. Add CLEAN fuel.
Reduce pressure to spec limit.
Clean or replace elements.
Install correct element.
See Trouble Shooting in Engine Manual.
Refer to Factory.
7.
Add