CL
DEVICE
RE
F. C
L
LHR SHOWN
LHR SHOWN
11/16" DIA. HOLE
5/16"
PAGE 6
5/16"
5/16" DIA. HOLE
7) DRILL MOUNTING HOLE.
REMOVE CHANNEL COVER AND DRILL 5/16" DIA. HOLE ON DEVICE REF. 5/16" FROM END OF CHANNEL.
8) CUT ACCESS SLOT IN CHANNEL COVER.
A) DRILL AN 11/16" DIA. HOLE 5/16" FROM THE CUT END OF CHANNEL COVER.
9) SLIDE TOP ROD THROUGH ROD GUIDE INSERT AND THEN ATTACH TO TOP LATCH USING 1/8"x1" COTTER KEY. BEND
COTTER KEY. UNSCREW ADJUSTMENT SCREW FROM BOTTOM ROD WITH BOLT AND SLIDE ON ROD GUIDE INSERT,
RE-SCREW THE ADJUSTMENT SCREW TO THE BOTTOM ROD, THEN INSERT BOTTOM BOLT THROUGH BOTTOM BOLT
GUIDE AND PLACE ADJUSTMENT SCREW INTO BRASS SLIDEBAR.
PAGE 11
ROD GUIDE INSERT
TOP ROD
ROD GUIDE INSERT
ADJUSTMENT SCREW
BOTTOM ROD
10) TURN ADJUSTMENT SCREW UNTIL IT IS APPROXIMATELY 1/2" INTO THE VERTICAL ROD. SWING RODS SO THAT THE
ADJUSMENT SCREW IS IN THE BRASS SLIDEBAR IN THE ACTIVE HEAD AS SHOWN BELOW.
LHR SHOWN
LATCH ASSEMBLY
(TOP LATCH SHOWN)
COTTER
KEY
