Ingersoll-Rand 7802SA, Product Information

Page: 3 / 36

04580502_ed5 EN-1
EN
Product Safety Information
Intended Use:
It is designed to cut steel, aluminum, tin and other materials up to 20 gauge (1 mm).
For additional information refer to Product Safety Information Manual Form 04580494.
Manuals can be downloaded from ingersollrandproducts.com.
Product Specifications
Models
Handle
Type
Free
Speed
Max.
Material
Thickness
Sound Level dB(A)
(ISO15744)
Vibration (m/s 2 )
(ISO28927)
Strokes/
min.
Gauge/
Inch/mm † Pressure (L
P
) ‡ Power (L
W
) Level *K
7802SA Pistol 4200 20/.04/1.0 83 94 3.0 1.0
† K
pA
= 3dB measurement uncertainty * K = Vibration measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
WARNING
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16573818 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-off valve 9. Oil
5. Hose diameter 10. Grease - during assembly
11. Grease - through fitting
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest
Ingersoll Rand Office or Distributor.