6
2
.
3.
4.
5.
Remove the cable clamp, connect the connection cable
and power cable with the terminal at the row of connection
and
tighten
the connection. The fitting line distributing must be
consistent with the indoor unit terminal of line bank.
1. Remove the handle at the right side plate of the
outdoor unit (ten screw).
Wiring should meet that of indoor unit.
Fix power connection wire by wire clamp.
E
nsure wire connections are tight and secure.
Install the handle.
ELECTRICAL CONNECTIONS
INS TALLER
4TXM6524A1030BA
Wrong wire connection may cause malfunction of some
electric components.After
tighten
cable, ensure that
leads between connection to fixed point have some space.
The connection pipes and the connectiong wirings of
the unit A ,unit B and unit C must be corresponding to each
other respective.
The appliance shall be installed in accordance with
national wiring regulations.
Note: the above figures are only intended to be a simple
e
h
t
o
t
d
n
o
p
s
e
r
r
o
c
t
o
n
y
a
m
d
n
a
e
c
n
a
il
p
p
a
e
h
t
f
o
m
a
r
g
a
i
d
appearance of the units that have been purchased.
To the power supply
To unit B
To unit A
cable
connection
power
connection
cable
cable
To unit C
connection
cable
Outdoor unit
Indoor unit
L1 L2
L1
L1
L2
L2
Power cable
A
B
C
D
connection cable
connection cable
connection cable
connection cable
1) The power cable should be put in from the hole under
connection cable cover.
2) If connecting with two indoor units, the connection cable
should be put in from hole A and hole B.
3) If connecting with three indoor units, the connection cable
should be put in from hole A , B and C.
4) If connecting with four indoor units, the connection cable
should be put in from hole A, B , C and D.
All power cables and connection cables must be protected with conduits.
5
5
Be sure the electrical supply is connected
to a equipment disconnect device approved
for this application.
Warning and Caution
1.
2.
3.
4.
Summary of Contents for 4TXM6518A1
Page 15: ......
