80203920_ed3
EN-1
EN
Product Safety Information
Intended Use:
This Air Impact Wrench is designed to remove and install threaded fasteners.
For additional information refer to Air Impact Wrenches Product Safety Information
Manual Form 04580916.
Manuals can be downloaded from www.ingersollrandproducts.com.
Power Management System
The 236G Impact Wrench incorporates a Power Management System that allows the operator
to select two power output settings (See 80200678 on page 2). To adjust the power, rotate the
Power Regulator to the desired level indicator. The number 1 indicator designates minimum
power output and the number 2 setting indicator denotes maximum power output. The power
level indicators are for reference and DO NOT indicate a specific power. The power output can be
further reduced in forward or reverse by using the variable throttle.
Product Specifications
Model Drive
Size
Recommended
Torque Range
Max. Torque
(Reverse)
Maximum
Free Speed
Blows Per
Minute
Tool
Weight
Overall
Length
ft-lbs (Nm)
ft-lbs (Nm)
rpm
BPM
lbs (Kg) inch (mm)
236G
1/2” 25-200 (34-271)
450 (610)
8000
1200
5.3 (2.4) 7.0 (179.0)
Model
Average Air
Consumption
Air Consumption
@ Load
Sound Level dB (A)
(ISO15744)
Vibration Level
(ISO8662)
cfm
l/min
cfm
l/min
† Pressure (L
p
) ‡ Power (L
w
)
m/s²
236G
4
113
24
680
90.3
101.3
5.9
† K
pA
= 3dB measurement uncertanity
‡ K
wA
= 3dB measurement uncertanity
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47083167 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
6.
Thread size
2. Regulator
7.
Coupling
3. Lubricator
8.
Safety Air Fuse
4. Emergency shut-off valve
9.
Oil
5. Hose diameter
10. Grease - through fitting
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest
Ingersoll Rand
Office or Distributor.
