2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by the
hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
International Warning Label:
Order Part No. ___________
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 50
For the Ratchet Housing:
Ingersoll–Rand No. 68
For the Impact
Mechanism:
Ingersoll–Rand No. 67
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C28–C4–FKG0
For USA– No. C28–04–FKG0–28
Where a permanent lubricator cannot be installed,
pour about 1.5 cc of Ingersoll–Rand No. 50 Oil into the air
inlet at the end of each workday. Operate the tool long
enough to coat the internal parts with oil.
After 25 hours of continuous use or more frequently if
necessary, inject 2–3 strokes of Ingersoll–Rand No. 67
Grease into the Grease Fitting (33).
Do not over–lubricate.
Periodically, inject several drops of Ingersoll–Rand
No. 50 Oil between the Ratchet Housing (31) and Ratchet
Yoke (36) to lubricate the Drive Bushing (35).
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
SPECIFICATIONS
Model
Drive
Free Speed
Recommended
Torque Range
H
Sound Level
dB (A)
♦
Vibrations
Level
in.
rpm
ft–lb (Nm)
Pressure
•
Power
m/s
2
1111 Model A,
1111–EU Model A
1/2”
300
10 to 50
(13.5 to 67.8)
88.7
101.7
10.9
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦
Tested to ISO8662–1 loaded with frictionbrake to 9 RPM
•
ISO3744
