SKYZER TECHNOLOGIES
PAGE 29 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE
Version 1.00
5.2.1
Dial-Up Configuration
1.0
QUICK DIAL?
1-YES 2-NO
This parameter sets up the speed of the terminal to dial. By default is selected as 1-
YES or press 2-NO to disable quick dial.
2.0
DIAL MODE?
1-TONE
2-PULSE
3-TONE/BLIND
4-PLUSE/BLIND
This parameter sets up the way that the terminal dials. Select the preferred mode
by pressing the corresponding number key.
1 = Tone - is the default setting.
In the default dial mode setting 1 (Tone), the terminal uses DTMF tones to dial the
number, but only after detecting a valid NZ dial tone. If a valid dial tone isn’t
detected, “Transmission Error” will be displayed.
2 = Pulse Dial – this communication setting is used for the older PABX systems
and is rarely used nowadays.
3 = Tone/Blind Dial – this is the same as Tone dial, however the modem ignores
the health of the dial tone on the line and simply dials the configured phone number
to call the host. This is used where the quality of the dial tone is low.
4 = Pulse/Blind Dial – this communication setting is used for the older PABX
systems and is rarely used nowadays.
3.0
PABX?
1A
or
1W
Press ENTER to bypass if no PABX prefix is required.
This parameter specifies the PABX numbers that the terminal dials to access an
outside line.
Note: The terminal pauses for 1 second after dialling if a control character ‘A’ is
inserted or to pauses for couple of seconds after dialling if a control character ‘W’ is
inserted after the PABX number. To insert a control character ‘A’ or ‘W’, press the
corresponding number key and then the FUNC key.
To remove a PABX number from the PABX field, press 1 and then press FUNC key
until space is displayed followed by ENTER.
4.0
HOST PHONE NO?
08797
This parameter specifies the phone number of Paymark network to dial to. By
default, the host phone number is set as 08797. Press ENTER.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
5.0
SAVE CONFIG Y/N
Terminal prompts to save configuration. Press ENTER to save configuration on the
terminal or CLEAR to exit and return to idle screen.
