IPP200 Series INSTALLATION GUIDE
296108772AD
900001778 R11 000 06 /0111
INGENICO – 192 avenue Charles de Gaulle – 92200 Neuilly sur Seine – France
Copyright © 2011 Ingenico
Tél. 33(0)1 46 25 82 00 - Fax 33 (0)1 47 72 56 95
Safety instructions:
Lithium battery:
IPP200 Series device is equipped with a lithium battery non-accessible to the user. Only a
qualified operator is authorized to open the unit and replace this component.
VORSICHT
:
IPP2 ist mit einer Lithium-Batterie, die nicht zugänglich ist für den Benutzer ausgestattet.
Der Wiedereinbau der Batterien muß von qualifiziertem Personal bewirkt werden.
Beachten Sie die Polarität für die Batterie Lithium. Eine fehlerhafte Installation der Batterie
kann eine Explosion führen. Entsorgen Sie die Batterien entsprechend den Anweisungen
des Herstellers.
CAUTION
: For Switzerland, Annex 4.10 of SR 814.013 applies for batteries
Power supply network: To cut off the IPP200 Series power, disconnect the power adapter
from the power supply network. You should provide a socket for the incoming power
supply satisfying the following conditions:
Socket
near the device and easy to access
;
Socket in line with the standards and regulations in force in the country of use;
The protection in the installation must be 20A for pluggable equipment type A.
FCC standard compliance marking certifies that the product stipulated below:
IPP2X0-01TXXXXX conforms to the following harmonized standards :
– part 15 subpart B of the FCC rules
This class (B) digital apparatus complies with Canadian ICES-003.
FCC
:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
CAUTION
: The user is cautioned that any changes or modifications not approved by
INGENICO could void user’s authority to operate the equipment
