20
/
25
5.4
Cleaning the terminal
Unplug all the wires from terminal.
Good rules for proper cleaning of the terminal are:
Use a soft cloth that is very slightly soaked with soapy water to clean the
outside of terminal.
Do not clean the electricalconnections.
Do not use in any case, solvents, detergents or abrasive products: Those
materials might damage the plastic or electrical contacts.
Avoid exposing the terminal to the direct rays of the sun.
Do not put anything into the slot of the smart card reader.
5.5
Transport and storage
Adopt general transportation mode, and prevent the goods from sunlight, snow, shower
and mechanical impact. Transport the devices with care, do not throw it forcibly. Prevent
the packaging from extrusion during transportation, to avoid breakage.
The product should be stored in the original packing box. The warehouse is not allowed
to have all sorts of harmful gases, inflammable, explosive, corrosive chemical goods,
strong mechanical vibration and strong magnetic field. Packing box should be at least
15cm above the ground, and be away from heat, cold, window or air inlet source at least
50cm.
6.
Standard
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
