INGENIA Titan GO, Product Manual

Page: 22 / 108

TITAN GO Product Manual | Connectors Guide
INGENIA | 2022-07-14 08:35:14 22
•
•
•
•
Plate PE Protective Earth. The assembly screws must be used as earthing
connectors. M8
Notes
Dimension the wiring according to the application current ratings. Higher section is always preferred to
minimize resistance and wire self-heating.
Recommended wire section is 20 mm² ~ 33.5 mm²
Never exceed the 9 Nm screw limit for the power connectors as this could cause permanent damage.
The torque generated by the cables or bus bars must never exceed 9 Nm in any axis. Take care to fasten the
cables or bus bars to prevent unnecessary forces.
5.2 Ring terminals and screws
Due to the high current ratings, ring terminals and screws are needed for the power terrminals. Following are shown
the recommended part numbers.
M8 screw Assembly
Description M8 allen screw, 12 mm
length
The following picture shows the correct order of
the mechanical elements and extra comments for
the assembly.
Extra capacitance
It is recommended to add extra capacitance to the main DC supply. The Titan Go has minimal DC bus
capacitance that is enough to filter high frequency currents and is enough for battery powered
applications. However it could not be enough in some cases and could damage the power supply by
demanding excessive current ripple. Add at least a total capacitance of 5 µF/ A (motor phase RMS) to avoid
stressing the power supply and minimize EMI problems. Use good quality DC link metalized polymer film
capacitors with low ESR (suggested polypropylene).

Maximum torque
The maximum torque applied to the
screws
must never exceed 9 Nm . It can
damage the connector and also the
printed circuit board.
