64
INGENIA IG3T
Cod. 420120239 REV. 1.1
4. INSTALLATION EXAMPLES
•
To use 2 stacked speakers, you need the optional LP-IG accessory. For further information,
please refer to the instructions of this accessory.
•
Always check that the handles, allowing the infra-red communication, are not obstructed;
never cover them and remove any dust or dirt deposits.
•
No installation other than that shown here is allowed.
INSTALLATION ON STAND
INSTALLATION ON SUBWOOFER WITH POLE
INSTALLATION ON SUBWOOFER
1 INGENIA IG3T can be installed in both stereo and mono configuration on an
optional standard tripod stand, with a pole having a diameter of 35 mm. The
maximum permissible height between the base of the speaker and the floor is 120
cm (47.25 in).
It is possible to use a single speaker mounted on 35 mm diameter pole. Additional
mechanical fixing, or fixing with straps, is required to properly secure the
installation. The maximum permissible height between the base of the speaker
and the floor is 120 cm (47.25 in). Once the installation is completed, follow the
subwoofer configuration instructions in the
ATTENTION!
•
Use an appropriately sized stand with the central foot forward to
ensure proper stability.
•
When “Stacked” on a tripode stand, the INGENIA IG3T cannot be
mounted in the configuration with 2 speakers stacked, but only
in a single speaker configuration, for safety reasons.
Using the GSA-IG accessory during the installation, you can use the speakers (1 o
2) mounted on subwoofer. This allows to get an extremely compact system, with
great output power over the whole range of sound frequencies, installed on the
ground. Additional mechanical fixing, or fixing with straps, is required to properly
secure the installation. Once the installation is completed, follow the subwoofer
configuration instructions in the
