Installation / Assembly
T-Rack
®
3.0 Series
– Assembly Instructions 1.1(2019-03) E inge
Page 41 of 84
© inge GmbH
5.5
Mounting the Bottom Frame
NOTE
CAUTION, PROPERTY DAMAGE!
Danger of system damage if the bolt head is not fully in place in
the adjustable foot M16.
Insert the bolt head in the adjustable foot M16 so that the head
is noticeably sunk into the adjustable foot M16 (see step 2)!
NOTE
The following description refers to mounting of the bottom frame on
the adjustable foot M16.
Optionally, the bottom frame can be mounted on the anchor
plates that are bolted onto the floor. A description of how to
mount the bottom frame onto the T-Rack
®
anchor plates can be
found in section
5.14.4 Mounting the Bottom Frame on the T-Rack
Step
Activity
Figure
1
Prepare the bolts
a)
Screw the hexagon nut (DIN 934) M16 closer to the bolt
head toward the bolt head until there is a space of 37 mm
to 38 mm between the bolt head base and the nut.
b)
Repeat step a) for all other pre-assembled hexagon bolts
(DIN 933) M16 x 150.
2
Prepare the frame foot
a)
Place an adjustable foot M16 onto the floor with the
opening facing up.
b)
Force the bolt head of a pre-assembled hex bolt into the
opening of the adjustable foot M16. The bolt head must
noticeably (by a few millimeters) be sunk into the
hexagonal opening of the adjustment plate.
Otherwise, there is a danger that it will sink down later and
cause strain, leaks and pipe breakage.
Nut
Bolt head
37 to
38 mm
