8|English
Additional safety instructions for cutting-off operations
Additional safety instructions for sanding operations
Additional safety instructions for polishing operations
Additional safety instructions for wire brushing operations
e)
Always use undamaged wheel flanges that are of correct size and shape for your selected
wheel.
Proper wheel flanges support the wheel thus reducing the possibility of wheel breakage. Flanges
for cut-off wheels may be different from grinding wheel flanges.
f)
Do not use worn down wheels from larger power tools.
Wheel intended for larger power tool is not
suitable for the higher speed of a smaller tool and may burst.
Additional Safety Warnings Specific for Abrasive Cutting-Off Operations:
a)
Do not “jam” the cut-off wheel or apply excessive pressure. Do not attempt to make an
excessive depth of cut.
Overstressing the wheel increases the loading and susceptibility to twisting or
binding of the wheel in the cut and the possibility of kickback or wheel breakage.
b)
Do not position your body in line with and behind the rotating wheel.
When the wheel, at the
point of operation, is moving away from your body, the possible kickback may propel the spinning wheel
and the power tool directly at you.
c)
When wheel is binding or when interrupting a cut for any reason, switch off the power tool and
hold the power tool motionless until the wheel comes to a complete stop. Never attempt to
remove the cut-off wheel from the cut while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the cause of wheel binding.
d )
Do not restart the cutting operation in the workpiece. Let the wheel reach full speed and
carefully re-enter the cut.
The wheel may bind, walk up or kickback if the power tool is restarted in the
workpiece.
e)
Support panels or any oversized workpiece to minimize the risk of wheel pinching and
kickback.
Large workpieces tend to sag under their own weight. Supports must be placed under the
workpiece near the line of cut and near the edge of the workpiece on both sides of the wheel.
f)
Use extra caution when making a “pocket cut” into existing walls or other blind areas.
The
protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause kickback.
Safety Warnings Specific for Sanding Operations:
a)
Do not use excessively oversized sanding disc paper. Follow manufacturers
recommendations, when selecting sanding paper.
Larger sanding paper extending beyond the
sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or kickback.
Safety Warnings Specific for Polishing Operations:
a)
Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle
your fingers or snag on the workpiece.
Safety Warnings Specific for Wire Brushing Operations:
a)
Be aware that wire bristles are thrown by the brush even during ordinary operation. Do not
overstress the wires by applying excessive load to the brush.
The wire bristles can easily penetrate
light clothing and/or skin.
b)
If the use of a guard is recommended for wire brushing, do not allow any interference of the
wire wheel or brush with the guard.
Wire wheel or brush may expand in diameter due to work load
and centrifugal forces.
