Disconnect power at the breaker. Remove two screws from one end of trim and slide trim off opposite end. Remove
grill by grasping it in the middle, flex grill up and lift it off. Unscrew and remove both end reflectors. Unhook element
clips at each end of the heater and remove nuts from end of element to remove the existing quartz tube. Carefully
install the new element. Remove one nut from end of the new element. Install wire by sliding high temperature ring
terminal onto element screw and replace nut. Use a thin 11/32" wrench to hold inside nut. Nuts must make a tight
connection. Close element clips over tube and reinstall end reflectors, and snap protective grill back in, then
reinstall trim.
REPLACEMENT ELEMENT INSTALLATION
NOTE: Hold ceramic element firmly while tightening
nut to prevent damage to element. Nut should
be tightened snug. A loose connection can
cause the element to short or fail prematurely.
(Visit infratech-usa.com for video instructions)
Need help?
To order replacement
elements for your Infratech heating
system, please contact us via phone
or visit our website.
Consult label on back of heater
for proper watts, voltage, and
replacement part number.
PART# ELEMENT# LENGTH WATTS VOLTS FITS MODELS
10-7025 E-1612-SL
22-3/8" (0.6m) 1600 120 SL-1612
10-7030 E-1624-SL
22-3/8" (0.6m) 1600 240 SL-1624
10-7035 E-2424-SL
35-3/8" (0.9m) 2400 240 SL-2424
10-7040 E-2428-SL
35-3/8" (0.9m) 2400 208 SL-2428
10-7055 E-3024-SL
56-3/8" (1.4m) 3000 240 SL-3024
10-7060 E-3028-SL
56-3/8" (1.4m) 3000 208 SL-3028
10-7075 E-4024-SL
56-3/8" (1.4m) 4000 240 SL-4024
10-7080 E-4028-SL
56-3/8" (1.4m) 4000 208 SL-4028
REPLACEMENT ELEMENTS
11/32” OUTSIDE NUT
11/32” INSIDE NUT
(SNUG TO CERAMIC)
5
Heater must be installed with the quartz tube horizontally level. For maximum tube life, use a level to find the
optimum position for the heater’s body. Always maintain the minimum clearances from the heater body to any
combustible materials.
11/32” OUTSIDE NUT
11/32” INSIDE NUT
(SNUG TO CERAMIC)
alfresco-heating.com
888-Warm-Glo