Wall Installation
The Hanging Plates (B) should be attached to
the shorter side of the heating Panel for vertical
Installation and to the longer side for a
horizontal installation. The plates are attached
by using the Bolts (C)
– 2 bolts per plate.
make sure that the corner of the panel
where the cable is attached is
not
used for
mounting the plates.
and that the slots in each of the plates are
mounted in the same direction (see picture)
and that the bolts (C) are only hand tight to
ensure no damage to the frame.
Screw the two bolts (D) into the integrated nuts
found in the opposite side of the frame from
where the plates are attached. These bolts
insure that the correct distance from wall to the
back of the panel is adhered too.
Measure the distance (X) between the slots and
transfer this measurement to the wall where the
panel is to be installed. Use a Level to ensure
that the marks for drilling are level.
Drywall Installation
Drill each of the holes with a 5/8-hole drill thru
the Drywall, or use the enclosed Wood screws.
if mounted to a stud in the Wall.
On Masonry
use the Anchor and Wood Screws.
Insert the Toggle bolts (E) into the holes; make sure that both are fully
inserted and tightened against the Wall with the Nut leave the Bolt
extended from the Wall 1 inch, use the wood screws for wood studs.
Screw in the Mounting Screws (E) up to the flange making sure that the
hooked part of the screw is vertical.
Lift the Heating Panel onto the Mounting Screws and then slide it to one
side insuring that both screws are in the dogleg part of the slots. This
insures that the heating panel cannot be easily removed from its
position.
5
Summary of Contents for US-64-M
Page 9: ......