LL28XX Tag Printer
Copyright © 2003-2021 InfoSight Corporation All Rights Reserved
Page iii
Optical/Laser Safety
INVISIBLE LASER RADIATION
AVOID EYE OR SKIN EXPOSURE TO
DIRECT OR SCATTERED RADIATION
CLASS 1 LASER PRODUCT, USING
A CLASS 4 EMBEDDED LASER (60W, 80W, or 100W, 10.57
– 10.63 μm)
The laser beam Exits the Final lens 7.5 inches from the tag
Never attempt to operate the Laser Tag Marker without the protective covers in place.
Never attempt to override any of the safety interlocks on the tag printer.
Never attempt to dismantle or repair the tag printer. In case of malfunction contact a Infosight service
representative.
Any of the actions mentioned above may result in permanent eye or skin damage. Refer to Laser Safety
section for more information on laser safety.
Labels / Warnings
Caution, Laser Radiation
– See Appendix
Warning label located on the side on the maintenance door and on
the top in front of the exhaust:
CLASS 4 INVISIBLE LASER
RADIATION WHEN OPEN
AVOID EYE OR SKIN EXPOSURE TO
DIRECT OR SCATTERED RADIATION
Warning label located above the rating plate on the side of the Laser
Marker, near the bottom, near the communications ports:
CLASS 1 LASER PRODUCT
Environmental
Conditions
The LabeLase® Printer is intended for Indoor use only. Altitude up to 6500 feet,
operating temperature 40 to 100 degrees F, 80% maximum relative humidity, rated
220VAC Fused at 5A 50/60Hz or 110VAC fused at 12A 50/60Hz according to Job
Number ( Legend plate on marker ), pollution degree 2.
NOTE: 220V models
both sides of the incoming line voltage are fused.
CAUTION
If this printer is not used in the manner specified by this manual, the
safety features provided may be insufficient.
Warning Label located on the side of the printer, near
the communications ports, regarding California
Proposition 65.
