Chapter 2:
Hardware installation
2
Hardware installation
2.1
Installation prerequisites
Take note of the following installation prerequisites before you start with the installation:
•
Static-free installation environment
Install the system in a static-free environment to minimize the possibility of ESD (electrostatic
discharge) damage.
•
Component check
Before the installation, ensure that you received all required components by verifying the package
contents with the
Unpacking List
document. This document is included in the package. If there are
items missing and/or damaged, contact your vendor for a replacement.
•
Memory modules
If you want to change the pre-installed DIMM modules, ensure that they are compatible and
purchased from a qualified vendor. Contact your vendor for the list of compatible DIMMs.
•
Cables
All cables that connect the system to the hosts are purchased separately. Contact your vendor for
the list of compatible cables.
•
Rackmount equipment
The rack slide rails are optional accessories. If you need to install it, see section
2.2.2 Installing the slide rail kit
IMPORTANT!
Install the system first to the rack or cabinet before installing the hard drives into the
system.
Ensure that you are familiar with the exact position of each plug-in module and interface connector. Also,
ensure to handle the cables with care when connecting between systems installed in the rack with a
correct routing paths carefully planned. DO NOT bend or twist the cables as this may cause emission
interference and accidental cable disconnection.
This chapter describes installing the modular components such as host boards, cards,
and other optional installation or connections such as expansions and rackmount.
