2-2
Chapter 2: Hardware installation
2.2
Installation procedures
This section details the installation procedures of the system, its components, and connections between
equipment. The installation procedures in this section are in order, so it is strongly recommended
that you follow the said order to reduce the time consumed during installation and prevent installation
mistakes, technical mishaps, or physical injuries.
2.2.1 Unpacking the system
When your system package has arrived, check and confirm if the contents of your package are complete
by referring to the
Unpacking List
document, which is bundled with in your package.
Accessory box contents
This box contains the following:
•
Serial port cable
•
Screws
•
Quick installation guide
•
Support CD (EonOne Management software and manual, firmware operation manual)
•
Product utility CD (Hardware manual)
Pre-installed components
Below are the components that are pre-installed in the system:
•
Controllers
•
LED front panels
•
PSU/cooling modules
•
DIMM modules
•
CBM (cache backup module)
•
Host board/s
Components that need user installation
You must do the following installation:
•
Assembling of the system to the rack/cabinet
•
Assembling the hard drives to the hard drive tray
•
Cabling in between systems
NOTE:
To install the system to the rack/cabinet, see section
2.2.2 Installing the rackmount kit
2.2.2 Installing the rackmount kit
This section details the overview of the rackmount kits, assembly, and installation with the storage
system.
IMPORTANT!
Contact our technical support team if you need further help in installing your system/
enclosure to the rack.
NOTE:
You can also watch this YouTube video on assembling the rackmount kit and installing the
system to the rackmount.