Using Remote Control to control the Device
Introduction to the Programmable Remote Control
Unit (optional)
If MAG520, MAG520w3 package includes a remote control
with a block of five programmable buttons (marked with blue
print colour), then you may want to choose these buttons for
controlling other devices (TV set, amplifier).
To program the buttons do the following:
1.
Press the «On/Off»
and «A/V»
buttons at the same
time and hold it for 2 seconds. When the green light of
the «On/Off»
button will stop blinking and will light
steadily, it means the RC is ready to learn.
2.
Press the button you want to «teach» — the green light will
start blinking.
3.
Place the infrared lamps of two RCs opposite each other and
press the button on the RC of the other device, the function
of which you wish to copy on device RC. Hold for 2 seconds.
4.
After the green light two quick blinks you may continue
programming other buttons.
5.
Repeat the procedure described above for all buttons you
want to program for controlling external devices.
6.
Press the the «On/Off»
and «A/V»
buttons to save
the programmed data; the green light should fade off.
Reset
Press «SETUP»
and «OK»
buttons at same time and
hold for 2 seconds red LED will flash 5 times. Reset is done.
