Using Remote Control to control the Device
This section explains how to unpack Remote Control
(RC) and prepare it for work. Your service provider
can supply the product with an alternative RC. In
that case please refer to the manual supplied by
your service provider. Remote Control requires
two batteries type AAA, R03, LR03, UM-4, 286.
Important information about using batteries.
Do not mix different types of battery or old and
new batteries.Do not use rechargeable batteries
with the remote control. Remove the batteries from
the remote control if you are not going to use it for
several weeks, to avoid the risk of leakage. Please
respect your environment and any local regulations and
dispose of old batteries in a responsible manner.
Caution! Do not attempt to recharge the
batteries.Immediately remove any leaking
batteries. Take care when handling leaking
batteries as they may cause burns to the skin
or eyes, or other physical injuries.
Introduction to the Programmable
Remote Control Unit (optional)
If MAG256/257, MAG256w2/257w2 package includes
a remote control with a block of five programmable
buttons (marked with blue print colour), then you may
want to choose these buttons for controlling other
devices (TV set, amplifier).
To program the buttons do the following:
•
Press the «On/Off» and «A/V» buttons at the same
time and hold it for 2 seconds. When the green
light of the «On/Off» button will stop blinking and
willlight steadily, it means the RC is ready to learn.
•
Press the button you want to «teach» — the green
light will start blinking.
•
Place the infrared lamps of two RCs opposite each
other and press the button on the RC of the other
device, the function of which you wish to copy on
device RC. Hold for 2 seconds.
•
After the green light two quick blinks you may
continue programming other buttons.
•
Repeat the procedure described above for all
buttons you want to program for controlling
external devices.
•
Press the the «On/Off» and «A/V» buttons to save the
programmed data; the green light should fade off.
Reset
Press SETUP and OK buttons at same time and hold
for 2 seconds red LED will flash 5 times. Reset is done.
