InFocus SP110 Page 3 Maintenance Download

Page: 3 / 3

NOTE

If the lamp door does not fit flush in the door opening, it is probably because the bail is

not completely folded down.

If you installed a new lamp module, follow the directions below to

reset the lamp timer

Plug the projector in and turn it on.

Press and hold down the

Volume –

button. While holding the

Volume –

down, press the

Source

button. Hold both buttons down for five seconds.

To verify that the lamp timer is reset, press the

Menu

button and navigate to the Source

menu. The lamp timer is the first item on the list.

Summary of Contents for SP110

Page 1: ...e the lamp door press the lip on the outside edge of the door until the door slides inward Then swing the door open 3 Loosen the two captive screws that secure the lamp to the lamp housing 4 Swing the bail on the top of the lamp module up from its storage postion and then pull the module out of the projector ...

Page 2: ...gnite o Make sure the bail on the lamp module is folded down in storage position It snaps into position o You must replace the lamp door for the projector to operate The door is completely shut when the caret on the edge of the lamp door points to the lock icon ...

Page 3: ...e follow the directions below to reset the lamp timer Plug the projector in and turn it on Press and hold down the Volume button While holding the Volume down press the Source button Hold both buttons down for five seconds To verify that the lamp timer is reset press the Menu button and navigate to the Source menu The lamp timer is the first item on the list ...