infobit iCam P11, User Manual, Page: 24 / 47

14
from the online device list.
6.1.2. WAN Connection
Please refer to the above diagram, user PC and the camera are in different routers, they are
considered as in a WAN, in this condition,
Client can’t search and find the camera automatically.
Client can still access the camera once below three conditions are satisfied.
Condition1: S
et camera’s IP address as static IP address
Set camera’s IP address in LAN
: connect user PC to the LAN (Router 1) where the camera is
connected according to LAN connection instructions, use application software CamCMS to search
and find the camera,
then add it to manage; then set camera’s IP address in the same network
segment as the router 1. Camera’s gateway is usually set at Router 1’s LAN IP address, for
example, 192.168.1.1,
then camera’s IP address can be set as for example 192.168.1.179 or
192.168.1.180 as long as they are in the same network segment.
Condition2: Router of the LAN where camera is connected supports Port Mapping
Router Port Mapping :
User’s PC logs into router configuration menu, gets into “Port Mapping”
(router management authorization may be required); refer to below picture,
DO NOT tick “Do not
apply this rule”, from first frame under “External port”, input any number from 1~65535, but
preferred to be set at more than 10000 like 10200 so there will be less port conflict possibility. From
“Internal IP”, input the camera1’s IP address 192.168.1.179, from first frame of “Internal Port”, input
3478,
(all cameras use this same port number). “Protocol” and “Mapping Line” can be default, from
“Note”, input “Camera 1’s mapping port” or something to understand.