Infinity Oreus HCS, Owner'S Manual

Page: 5 / 10

8. Put the pivot back into place. Re-fit the cover plate and replace
the two fixing screws. Do not fully tighten the screws at this stage
because you will need to rotate the pivot later in the assembly
proceedure to angle your speakers correctly.
Attach the foot to the speaker
1. Remove the two screws and take off the rear cover plate from the
the speaker. Use the hex key supplied to loosen the screws.
2. The foot can be attached to the speaker at two different
positions. The first position allows the speaker to be used vertically
(normal for satellites), while the second allows it to be used
horizontally (normal for the center channel). Note the blanking
plug which fills the unused pivot hole on the rear of the speaker.
3. Connect the cable to the speaker terminals. Observe correct
polarity. Speaker cable is usually colour-coded (red or white for
positive) or provided with an identifying stripe or rib on the positive
conductor. Connect the positive conductor to the red speaker
terminal.
4. Insert the pivot into one or other of the two pivot holes in the
speaker, depending on whether you wish to use the speaker vertically
or horizontally.
5. Fit the blanking plug into the unused pivot location hole and
then re-fit the rear cover on the speaker. Tighten the fixing screws.
Adjust the angle of your speaker
1. You can tilt your speaker up or down on its foot and you can
also rotate it. If you experience difficulty tilting or rotating your
speaker, try loosening the fixing screws for the pivot cover plate on
the foot.
2. Once you have adjusted your speaker the way you want it, fully
tighten the fixing screws of the pivot cover plate on the foot. This
will hold your chosen adjustment
Assembling the stand
1. The Oreus stand is supplied with the base detached from the
column.
A
SSEMBLING THE
F
LOORSTAND
7. If you want to hide the speaker cables in the wall you can use the
cable entry hole in the underside of the base.
6. Feed the speaker cable through the cable-entry hole in the base
and then through the pivot.
5
UK