45
If you experience any difficulties inflating or using your kayak,
see below for solutions:
Further technical information can be found at our website:
www.infinitykayaks.com
Check valve gaskets and make sure the fabric shell is not interfering
with the seal. The valve must be closed tightly.
Check for pin hole punctures - see Owners Manual for repair
instructions.
If the air chambers are not aligned with the valves in the centre of the
holes:
a) Unzip the cover.
b) Partially inflate the chamber.
c) Realign the air chambers to the correct position within the
fabric shell.
d) Close zip cover and inflate chambers with the footpump
provided.
e) If the valve becomes impinged by the fabric, it can put
pressure on the valve. To prevent this, ensure the valve stays
clear of the fabric hole during inflation.
Ensure the air chambers are aligned.
If a zipper is stuck, do not force it open. Instead, wash with a
toothbrush and soap and water. Rinse completely once opened.
Never unzip the cover when the kayak is inflated.
Use the drain plug in rear of hull to drain water from the kayak and
wipe down with high-absorbing sponge. Store the kayak inflated until
dry. Do not place in direct sunlight to dry. Do not store while wet.
Slow leak
Still leaks slowly
Valves don’t align
Doesn’t inflate
Stuck zipper
Drying kayak
Problem
Solution
11. TROUBLESHOOTING
