青岛银菲特精密机械有限公司 WEB:www.china-infinity.com
Qingdao infinity precision-Machine Co., LTD
5
减速机由
6
个
M20
的螺栓固定于车架减速机固定架
(
图
3).
车架减速机固定架需满足的技术要求为
:
平面度为
0.15 mm.
表面粗糙度为
12.5 µm. (
图
4).
6
个
M20
减速机固定螺栓的拧紧力矩必需满足
10.9
级
M20
螺栓的最小拧紧力矩要求
(
毎侧三个螺栓
)
。
拧紧力矩必须大于
600Nm
。
此
6
个螺栓及其配套螺母要与垫圈配合应用
(
图
3
和图
4)
。
在车架减速机安装台面减速机安装座输入轴端两侧焊接金属挡块来确保减速机无水平面前后方向的相
对位移
(
图
3
和图
4)
。
The gearbox is fixed on the drum by 6 M20 screws (see fig.3).
You should prepare a frame support with surfaces belonging to the same plane and with a flatness of 0.15mm
and a superficial average roughness about 12.5 µm. (see on fig.4).
You must fix the gearbox on the frame by 6 M20 screws (tree for each side) with a minimum resistence class
equal to 10.9. The tighten torque required should not be less than 600Nm.
You must use washers for screw and nuts (see Fig.3 and 4).
A complete installation requires to weld on the frame a mechanical stop, one for each side, previously placed
in beat on the gearbox (Fig. 3 and 4).
