Infinity Solutions LMQ II, Service Manual

Page: 7 / 30

3
down),resting it on the
Electrical Side Cover
so that the side
Electrical Side Frame
is seated properly in the side
cover.
5. Remove the
Conveyor Drive O-Ring
[Figure 6].
6. Remove the
Feed Drive Belt
[Figure 6].
7. Remove the
Plastic Roll Gears
[Figure 6].
a. Remove the
E-clips
from the shafts.
b. Slide the
Plastic Gears
off of the shafts
8. Remove the
Roll Gears
[Figure 6].
a. Loosen both set screws 2-3 turns.
b. Pull the gear off of the roll.
c. Remove the key from the roll.
9. Remove the
Motor Gear
[Figure 6].
a. Loosen both set screws 2-3 turns.
b. Pull the gear off of the motor shaft.
c. Remove the key from the motor shaft.
10. Remove the
Idler Gear
by removing the shoulder-bolt on which it is mounted [Figure 6].
11. Remove the
Feed Drive Pulleys
[Figure 6]
a. Loosen the set screws 2-3 turns.
b. Pull the pulleys off of the shaft.
12. Remove the
Conveyor Drive Pulley
[Figure 6].
13. Disconnect both leads from the
Door Switch
[Figure 6].
14. Remove the screws which attach the
Feed Table
,
Feed Idlers
,
Feed Gauge
,
Base Plate
,
Conveyor
and
Motor
Covers
[Figure 3].
15. Remove the two
Feet
on the motor side of the machine.
16. Remove the two
Base Plate Screws
from the motor side of the machine.
17. Remove the
Motor Mount Screws
. Be careful to catch the
Motor
before it drops. Gently let it rest on the
Electrical
Side Frame
.
18. Slowly pull up on the
Motor Side Frame
. As you pull the frame off of the rolls, reach under and push the
Slide
Block
[Figure 3] up against the
Motor Side Frame
so that it stays with the frame as you remove it.