INFINITI FITNESS ENDURO Series CR3100, Assembly Manual

Page: 10 / 20

STEP 1 – Install Pedals
R
L
Insert the Right Pedal (D-17R) into the right arm of the Crank
assembly and finger tighten in a clockwise direction until the
thread is fully inserted in the crank.
Repeat for the Left Pedal (D-17L) finger tighten in an anticlockwise
direction. Tighten both with the wrench.
STEP 2 – Install Handlebar Post
Take off screws and washers from handlebar post (C-4/C-5/C-6).
Connect upper hand pulse wire (C-7) hand pulse wire bellow (D-29)
2 pin upper computer cable (C-9) and computer cable bellow (D-31).
, cable ( C-8 & D-30)hen combine handlebar post (C) with main frame by screws,
flat washers and wave washers with screws and washers.
STEP 3 – Install Handlebar
Insert two hand pulse wire with body fat (B-1) into left and right hole of handlebar post then pull them out from handlebar post.
Screw handlebar (B) to handlebar post by screws (K) and spring washers (K-1).
STEP 3